News

Home / News / Industry News / The Influencing Factors of Life of Automotive V Belts

The Influencing Factors of Life of Automotive V Belts

Update:21-04-2017
Summary:

We can see the transmission belt everywhere in our live […]

We can see the transmission belt everywhere in our lives. Rubber belts are mostly used in industrial belts, car belts and conveyor belts, its product quality is directly related to the production line of production efficiency and safety, small flaws will lead to product production stagnation, large quality problems will lead to product losses, so It is particularly important to check the rubber belt analysis. It is not important to the importance of the car. So what do you know about the factors that affect Automotive V Belts?

Automotive V Belts on the transmission system is very high, the same transmission plane parts of the same degree and coaxial degree directly affect the belt life, easy to produce noise. In the entire drive plane only the drive belt belongs to the rubber parts, and any part of the belt caused by the belt with the parts of the interference of the milk seriously damaged the belt. After the drive face for a long time, due to wear and other reasons is likely to destroy the original parts of the same degree or coaxial. So we have to check the operation of the end of the situation.

Due to the complexity of the state of the car, it is highly likely that the belt or pulley will be spilled into the foreign body in an externally harsh driving environment. If the foreign body is moving at high speed, it will be like a knife. Belts damage. If you are traveling in a harsh environment, check for foreign matter.

Cords are also an important part of Automotive V Belts, which at the small bending radius will cause the belt to pull the attenuation. Especially the timing belt. Because its cord is made of glass fiber. Glass fiber, relatively fragile, this cord even in a small bending radius will cause a serious attenuation of the belt tension. So prohibit excessive bending timing belt. If the belt is under a small bend radius, it should be wrapped on a round bar to prevent the belt from bending at an acute angle.