News

Home / News / Industry News / One Type of Drive Belt - Serpentine Belt

One Type of Drive Belt - Serpentine Belt

Update:05-12-2016
Summary:

Take a look underneath your car and you will most likel […]

Take a look underneath your car and you will most likely find a belt or system of belts attached to pulleys on the front of your engine. If there is only one Drive Belt wound through several different pulleys, you are looking at a serpentine belt. The serpentine belt is different from other types of driver belt systems because the serpentine belt is one long, continuous belt that is connected to several different devices. Older systems employed the use of numerous drive belts to drive the devices in the engine compartment, but after the development of the serpentine belt in 1979, most cars began to use this system for efficiency and ease of use.

Peripheral devices such as the power steering pump, alternator, and air pump all connect to drive belt systems. In the past, two or three of these peripheral devices would be connected to each other, but not to all peripheral devices. Therefore, if one of the drive belts broke, the driver might be unaware of the loss of one device. Because the serpentine belt connects all the pulleys of peripheral devices, the driver will notice quickly if the belt breaks because all peripherals, including power steering, will immediately suffer or shut down entirely.

In addition, serpentine belts are much easier to install than individual drive belts. There is usually one movable pulley putting tension on the serpentine belt, so replacing the belt involves simply loosening that pulley, removing the old belt, replacing it with a new serpentine belt, and tightening to the appropriate specifications. Older systems necessitated a mechanic to identify which belt was broken and work around other belts and engine components to replace the belt.

Serpentine belts are less prone to stretching and breakage than smaller and weaker individual drive belts. Tension is more equally distributed along the length of the belt, thereby reducing slippage and stretching. Because serpentine belts are typically longer, larger, and wider than individual belts, they tend to last longer and resist frequent breakage.