News

Home / News / Industry News / Car Maintenance of the Automotivedrivingbelt Timing Belt

Car Maintenance of the Automotivedrivingbelt Timing Belt

Update:07-01-2017
Summary:

The timing belt connect the crankshaft with the camshaf […]

The timing belt connect the crankshaft with the camshaft. With the belt in place, the crankshaft can then drive the camshaft which will allow the opening and closing of the valves. If the belt breaks, the valves will open at different times and then be struck by the pistons. Often the pistons will crack or break. This is very costly.

You should take the responsibility of car care when you want to bring home one. Not only is car maintenance important to make your vehicle last longer - saving you from having to purchase a new one every 5 years or so - it is also mandatory to ensure that road accidents are avoided as much as possible.

As a responsible driver, you should give your car a a routine check by your trusted mechanic and daily monitor its running condition as well.

So you will have to monitor your car properly just in case the belt is worn out or just about to break. Normally your mechanic will advise you accordingly as to when you should have the belt replaced.

It is vital to keep the timed motion of a car. Failing to do so will result to a collision between other car parts such as the valves, cylinder head, cylinder walls and pistons. The belt, then, was made to prevent such incident from happening. The belt syncs the mechanism of the engine every time the car is in motion. It rests on two crankshaft pulleys and each of these contain a timing mark. It is important that these marks are arranged according to the timing specifications of the car. The pulleys are then toothed to prevent the belt from slipping off or sliding around the pulleys. These are all commonly preserved movements that help in the successful running of the car.

Because the belt is made from rubber, it is prone to stretching and breaking due to too much heat. As heat penetrates to the belt, it stretches and deteriorates causing the teeth of the belt to wear out. If there are no teeth to secure the belt, a collision of car parts is made possible. You should ask a certified mechanic check up or inspect your car to avoid this happening. Prevention is better than the cure as this would lessen the cost of car repair and maintenance.

Furthermore, preventing the Rubber Timing Belt from breaking can't be done, a replacement remains as the only solution. It is recommended that the car's timing belt is replaced every 50,000 to 70,000 miles. This is, however, dependent on the car's replacement intervals for timing belts. This auto repair service usually costs between $250 and $750. Your expenses will vary according to the condition of the belt's damage.